Parts other than what’s on the car

1. 2 Spare  BAE Billet 100 tall short blocks, 4.675 bore :
Both have New BRC rods, Bryant cranks, cams, new sleeves, new  
J &  E pistons & pins, C & A rings, pans, One has front RCD drive
cover and gears with Layhe pickup,  front hub, pan. About 3 runs on
each this year since freshened.

2. BAE intake manifold

3. Extra set of BAE stage 5 heads, most all new bead lock valves and
Nex Tex springs on Intakes    

4. Spare waterman red 990 pump, with 18% underdrive

5. 2 new set’s of GRP Billet rods

6. 1 new set of Brooks Billet rods

7. 1 new set Earson Professional valve springs

8. 30 Plus new push rods

9. 50 used push rods

10. Fresh Spare Lenco 164 gear trans.  New set of  clutches and disk

11. 18 new titanium standard and bead lock valves

12. Two new pistons.

13. 7 new rocker arm stands

14. New, one intake and one exhaust rocker shafts

15. 16 Piston buttons

16. 2 sets new of new Z gap rings

17. 8 boxes of  new assorted rings by C&A Extreme

18. 10 Stage 5 intake rockers, two new ones back ordered

20. 2 new BAE exhaust rockers

21. 2 Crower 10.7 complete clutches. One has Titanium doughnut. Have
  20 plus floaters and 20 plus disk ready to run. 4 new floaters no
  runs,  others are .340 to 300. There is enough to last a season.
  Clutch weights and dial gauge to set.

22. 3 boxes crane lifters

23. 150 new spark plugs

24. 9 ½” ring and pinion 4.10 almost new

25. 9 ½” ring and pinion 4.30 OK for back up

26. Backup cam

27. Fresh backup Bryant 4.125 crank

28. 4  New  4.675 “sleeves

29. Several boxes old sleeves  

30. New Monte Carlo windshield

31. 2 back up drive shafts

32. 2 sets of rear drive shaft couplers male and female

33. Spare clutch drive shaft

34. 2 trans couplers

35. 11 10.5 Bonntafante clutch disk

36. 8  10.5 Bonnifante clutch floaters

37. Assorted # 3-4-6-8-12-16 fuel, oil fittings and steel braded lines

38. 300’ ¼” fuel lines on roll. With fabricating tools

39. Bonnifante clutch set of weights with dial setting gauge

40. 2 Nut and bolt boxes, 18 drawers each. Contains everything needed
  to run the car, blower studs 5 new sets, valve cover studs new,  head
  studs, ect.

41. Gray 6 drawer box, contains specialty fittings of all kinds, hat
  linkage, zuss fasteners, new starter brushes ect.

42. New set of  hat butterflies

43. 2 new blower belts one used

44. New 6 head gaskets .062,   2 head gaskets .081

45. 4 new oil pan gaskets

46. 4 new valve cover gaskets

47. Assortment of used gaskets

48. Several sets of new fuel lines (we make ours)

49. Assorted boxes of air fittings with ¼” and 1/8” lines

50. Assorted fuel pump parts and fittings

51. Set of fuel pump 1200 gear set

52. 20 plus , Valve cover spark plug tubes

53. Back up bell housing titanium snout and bearing

54. Spare set of rear brake steel rotors, hubs and pads

56. 2 tire liners

57. New,  3 or 4 rear main seals

58. New,  6 rear main side rubber gaskets

59. 6 new hardened crank keyways

60. 6 front cover oil seals

61. Spare 44 amp Generator  ( Charlie’s)

62. Fresh  spare set of Fire Fox fire bottles with SFI tags

63. 4 more fresh  fire bottles no sift tags

64. 10 cases of Brad Penn 70 Weight oil

65. 3 boxes of assorted o rings

66. 44 amp MSD timing retarder

67. 44 amp pro mag box without rev limiter

68. 3 MSD pro mag boxes with rev limiters

69. 2 MSD coil’s Black

70. Back up mag drive

71. Assorted boxes of caps,  plug wires,  ect. Some new

72. New, 3 racks of  upper rod bearings

73. New, 2 sets of complete rod bearings

74. 1 set of new cam bearings

75. 4 new flywheel center bearings

76. Several 12” X 12’ Square card board boxes of computer and wiring
   parts
Morrison Racing
405-692-4479